Quantifying differences in femoral head and neck asphericity in CAM type femoroacetabular impingement and hip dysplasia versus controls using radial 3DCT imaging and volumetric segmentation

Objective: Femoroacetabular impingement (FAI) and hip dysplasia are the most common causes of groin pain originating from the hip joint. To date, there is controversy over cut-off values for the evaluation of abnormal femoral head-neck anatomy with significant overlap between the normal and abnormal hips. Our aim was to perform three-dimensional CT analysis of femoral head and bump anatomy to quantify common hip pathologies (FAI and hip dysplasia) vs controls. Methods: Consecutive patients who underwent three-dimensional CT imaging for hip dysplasia or CAM type FAI were compared to asymptomatic controls. α angles on radial CT and 3D volumetric femoral head and bump segmentations were performed by two readers. Inter- and intrapatient comparisons were performed including interreader and receiver operating characteristic analyses. Results: 25 FAI patients, 16 hip dysplasia patients and 38 controls were included. FAI and dysplasia patients exhibited higher α angles and higher bump-head volume ratios than the controls (p < 0.05). Larger bump volumes were found among FAI than dysplasia patients and contralateral hips of FAI patients were also different than the controls. α angle at 2 o'clock and bump to head ratio showed the highest area under the curve for patients vs controls. The interreader reliability was better for volumetric segmentation (intraclass correlation coefficient = 0.35-0.84) as compared to the α angles (intraclass correlation coefficient = 0.11-0.44). Conclusion: Patients with FAI and dysplasia exhibit different femoral head anatomy than asymptomatic controls. Volumetric segmentation of femoral head and bump is more reliable and better demonstrates the bilateral femoral head anatomy differences in hip patients vs controls.