Expression, purification and characterization of the monomeric and dimeric forms of soluble bovine endothelin converting enzyme-1a

In this study, the catalytic domain of bovine endothelin converting enzyme-1a (ECE-1a) was cloned into a baculovirus transfer vector behind the human alkaline phosphatase signal sequence. The recombinant baculovirus was then used to infect High Five™ insect cells in suspension culture. Both the monomeric (85 kDa) and dimeric (170 kDa) forms of soluble ECE-1a were purified to electrophoretic homogeneity from concentrated culture media following sequential concanavalin A, SP-Sepharose, Mono Q and gel filtration column chromatography. Typically, approximately 11 mg of ECE-1a monomer and 6 mg of dimer were obtained from 1 litre of culture medium. No interconversion of the two forms was detected after purification. Both forms of ECE-1a had a pH optimum of 7.0, were maximally stimulated by NaCl at a concentration of 500 mM, and were inhibited to the same extent by metalloprotease inhibitors such as phosphoramidon and EDTA. However, in kinetic studies using big endothelin-1 (ET-1) as a substrate, the K_m and k_cat values for the monomer were 2.2 μM and 1.6 min^-1 respectively, while those of the dimer were 1.4 μM and 4.9 min^-1 respectively. These results show that, although the two forms of ECE-1a behave similarly in many aspects, the dimeric enzyme is more efficient in catalysing the conversion of big ET-1 to ET-1. The present protocol can be utilized to prepare large quantities of both forms of ECE-1a for further biochemical and structural characterization.